top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

LTE: How connected mode DRX and Idle mode DRX are configured ?

+1 vote
1,239 views

Which messages eNodeB uses to configure connected mode DRX and idle mode DRX for an UE ?

posted Oct 20, 2017 by Ganesh

Share this question
Facebook Share Button Twitter Share Button LinkedIn Share Button

1 Answer

+1 vote

Connected mode drx parameters are configured through rrc reconfiguration msg to ue .
UE reads idle mode drx parameters from sib2.

answer Oct 26, 2017 by Veer Pal Singh Yadav
Similar Questions
+2 votes
Which operator supports connected mode DRX?

i want to analyze connected mode DRX logs can anyone suggest the operator which supports connected modem DRX so that i can collect logs and analyze.

0 votes
Can ue monitor the PDCCH after SR transmission in DRX mode?

SR is transmitted and UE is in DRX mode, can UE monitor the PDCCH even after active timer expires?

+2 votes
When UE is in the Connected State, How UE could use DRX configuration which is intended to use in IDLE state?

During my study about the measurement and ANR, I have the question. Please help to let me get the proper answer.
[ Condition]
1. UE is in the connected state.
2. UE measures one PCI and reports it to eNB but it does not belong to NRT(Neighbor Relation Table) in eNB.
3. eNB sends rrcConnectionReconfigurationMessage to read CGI for that PCI.
4. UE should read MIB/SIB1 to report CGI info to eNB.

In Step 4), In some materials on the web, UE should use IDLE periods to get SIB1, which is configured as DRX config in rrcConectionReconfigurationMesage. Because Measurement Gap is too short to read MIB/SIB1 and it's only for the measurement purpose.

[Question]
When UE is in the Connected State, How UE could use DRX configuration which is intended to use in IDLE state?

As my basic understanding, DRX configuration is to improve the battery life in idle mode.

...