top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

Does UE reads MIB in connected mode?

+1 vote
866 views

IF yes, then how frequently UE reads the MIB? Does eNB changes the MIB parameter in run time?

posted Feb 13, 2020 by Jaganathan

Share this question
Facebook Share Button Twitter Share Button LinkedIn Share Button

1 Answer

+1 vote
 
Best answer

Hi Jagan,

Usually MIB/SIB1,2 is one time read process and UE stores the Tag value to track . Ue will not read these messages until it receives the SYSINFOMODFY message in Paging. Once UE gets the paging with SYSINFOMODFY then it applies the initial Broadcast acquire procedure. Which will include MIB/SIB1,2 reading procedure.
UE can receive this paging either in connected mode or idle mode. So Connected modem reading MIB is possible.
Frequent of reading is depends on the no eNB paging for modification of broadcast info.

Possible of changing MIB in runtime is possible but with limited way. if you change the BW in run time then UE should adapt to new BW by initial SYNCH procedure, so it is not allowed. I guess eNB can change the HARQ duration parameter runtime (But not sure ).

answer Feb 14, 2020 by Rohit Verma
Similar Questions
+1 vote

Why UE requires SIB info chang paging in connected mode?Does UE read SIB only after paging or will he monitor PDCCH with SI-RNTI in all SF?

+2 votes

In case of 5CA, If the Scell sends different TM mode in each Scell. how UE supports this?

+1 vote

In case of LTE out of service can UE serviced by NR alone in Non stand alone architecture ?

0 votes

because NR MIB is equivalent to LTE SIB? So Which RNTI used for MIB in 5G?

+1 vote

What is the use of pdcch-ConfigSIB1 in MIB of 5G?

...