top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

how can we get to know when the session completed when it is cofigured as run continuosly

+1 vote
321 views

I have scheduled my workflow to run continuosly and it was partition enabled one. There are 5 sessions presents in my workflow and I want to do some actions after the session gets completed.

Since i configured this as Run Continuosly it will not go to the succeeded status and it will be always in running status only. But I want here to do some post session success tasks after the each session successfully completed its process.

Thanks in advance

posted Jun 18, 2014 by Sunil

Share this question
Facebook Share Button Twitter Share Button LinkedIn Share Button

1 Answer

0 votes

Sessions are not marked for run-continuously, workflows are.
Even though workflow is running continuously, the sessions can still have pre and post session tasks. that should be your solution.

answer Jun 20, 2014 by Shweta Singh
Similar Questions
+1 vote
Informatica: If session fails after loading 10000 records in the target, how can we load 10001 the record when run next?

If session fails after loading 10000 records in the target, how can we load 10001 the record when we run the session in the next time?

+2 votes
Can we create the targets at run time using informatica Powercenter

When we do not know the number of targets, Can we create the targets at run time using informatica Powercenter.

Suppose we have below source:
Employee: 

Dept_ID      EmpName  Sal
10           A        200
11           B        100
10           C        200
10           D        400
12           E        500
12           F        400

...

It can have any number of distinct Dept_ID. I want to load all EmpName and Sal of a particular Dept_ID into a separate target table (i.e target name should be as Tar_10 or Tar_11 where 10 & 11 are Dept_ID).

...