top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

Is it possible to have X2 interface between two eNBs in which one eNB have IPv4 and other have IPv6 protocol stack?

+3 votes
636 views
Is it possible to have X2 interface between two eNBs in which one eNB have IPv4 and other have IPv6 protocol stack?
posted May 19, 2015 by Veer Pal Singh Yadav

Share this question
Facebook Share Button Twitter Share Button LinkedIn Share Button
Cirrect me if I am wrong, least 4 bytes of IPv6 address is IPv4 address which can be used for IPv4 routing. So ideally there should not be any problem. (not sure if there is any x2 angle to this)
commented May 19, 2015 by Salil Agrawal

1 Answer

+1 vote
 
Best answer

IPv4 and IPv6 cannot talk to each other without having a translator between them as these are two different protocol stacks. The IPv4 packet can contain destination IP address which can be IPv4 only. Same is applied for IPv6 as well.
But if a translator device like NAT64 is present in the middle, X2 link is possible.

answer Apr 26, 2019 by Prashant Verma
Similar Questions
+3 votes
Establishing X2-Connection Between two ENBs where operator for them are different is possible or not ???

Consider Two ENB of two different operator can they establish X2-AP Connection if X2-AP Support is there ???

I guess it is possible as ECGI will give unique identification to them . (Though possibility of CGI is same) ...

is there any other scenario like x2AP- is not possible between them

...