top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

LTE: What does mean by attach in S101 mode ?

+2 votes
2,551 views

While going through the NAS protocol, One section has mentioned about attach in S101 mode . I didn't get the context.
Can someone please share his/her thoughts on this context ?
Thanks in advance.

posted Sep 17, 2015 by Harshita

Share this question
Facebook Share Button Twitter Share Button LinkedIn Share Button

1 Answer

+1 vote

I don't have deep understanding of S101 interface. I went through the different reference materials and would like to share what I got as following:

  • S101 interface is based on GTPv2-C protocol.
  • S101 interface is used to enable handover signalling between E-UTRAN and CDMA2000 networks.
  • S101 interface exists between MME (LTE network node) and HRPD (CDMA2000 network node)
  • All the signalling messages over the S101 interface don't use TEID in message header.
  • PMIP protocol is used to carry signalling and data packets.

Due to very limited knowledge in this interface. I explained a little bit.
Expecting response from other telecom professionals as well.
And also please correct me if I wrote something wrong.

answer Sep 18, 2015 by Vimal Kumar Mishra
Thanks Vimal.
commented Sep 19, 2015 by Harshita
You are the best.
commented Jan 31, 2018 by anonymous
Similar Questions
+2 votes
LTE: Does UE send APN information within the Attach Request message ?

Does UE send APN information while registering with network using the "Attach request" message ?
How MME come to know that UE should attach to APN "XYZ" ?

+2 votes
LTE: What does means by non-current native EPS security context ?

when and what is the use of such type of security context ?

+4 votes
Why Identity Request Need to be perform by MME after successful Authentication and Security Mode Complete...?

I saw a scenario where an Identity is requested by MME after successful Authentication and Security mode complete.. As a Response to this message UE is Sending IMEI? what is the need of checking IMEI number after successful authentication? If IMEI is in block list then ongoing Attach procedure is going to be Terminate...? Identity Request intention is mainly to check the IMEI belongs to any one of Black, while or Green list then why cannt MME check for this before Security Mode?

...