top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

How UE will use SIB6 information during IRAT HO?

+2 votes
420 views
How UE will use SIB6 information during IRAT HO?
posted Oct 15, 2015 by Gnanendra Reddy

Share this question
Facebook Share Button Twitter Share Button LinkedIn Share Button

1 Answer

+1 vote

UE will use SIB6 information to get to know about inter rat neighbours.So in RRC_IDLE state UE will read all present System informations based on the scheduling information present in SIB1 and will get to know about all neighbours to serving cell including inter/intra rat/frequency.
Basically SIB3 to SIB8 used by UE for cell selection/re-selection.

answer Oct 15, 2015 by Ashish Barapatre
Similar Questions
+3 votes
How many times UE can send rach when ue try to sync at target enb during HO

Suppose UE have mobility parameters for intra LTE HO . UE try to sync with target eNB to confirm HO completion. So UE performs rach with target eNB. Suppose rach is not getting successful then how many time UE will perform rach at target eNB .

+3 votes
How to inform MME about UE movement from eNB1 to eNB2 after UE sending Re-establishment-HO failure to eNB2 during HO?

How to inform MME about UE movement from Source eNB to Target eNB after UE sending Re-establishment with HO failure to target eNB during handover. In this case HO notify or path switch is applicable ?

0 votes
ue send s-tmsi in place of ue id in rrc con req, will s-TMSI remain same in case of HO also ?

ue send s-tmsi in place of ue id in rrc con req, will s-TMSI remain same in case of HO also ?

...