top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

LTE-A: Does the radio link failure applicable for secondary cell ?

0 votes
1,050 views

If my understaing is correct then in case of carrier aggregation(CA), an UE can connect to multiple cells. One of the cell is known as primary cell while other cells are known as secondary cells. Primary cell physical layer failure is detected based on the receiving N310 consecutive "out of sync". Is the same case applicable for secondary cells as well ?

posted Jan 8, 2016 by Harshita

Share this question
Facebook Share Button Twitter Share Button LinkedIn Share Button

1 Answer

0 votes

As per 36.331... Physical layer monitoring and related autonomous actions do not apply to SCells.

So radio link failure is applicable only for Pcell.

answer Jan 9, 2016 by Veer Pal Singh Yadav
Thanks for your answer.
Similar Questions
+1 vote

An UE configured for carrier aggregation, may have different radio channel conditions for primary and secondary cells.
I meant to say, primary cell may have strong signal strength at the same time UE may observed secondary cell(s) not too good.
In this case, does the same modulation and coding schemes used for primary and secondary or may use different coding and modulation schemes for different channels for the same sub frame?

+3 votes

I went through 36.331 spec, there are various terms such as Srxlev, Q-hyst and so on are used.
Can someone please give a brief overview of all the terms used during the cell selection and cell re-selection procedure ?

+5 votes

What is the limit of neighbors for a LTE Cell
1> Max No. of Intra LTE Neighbors (Same eNb & Neighbor E-NodeB)
2> Max No of nbrs for IRAT (GSM/CDMA/3G) per eNb cell
3> Max no of nbrs which can be defined on S1 interface
4> Max no of nbrs which can be defined on X2 interface

...