top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

How DL and UL Data buffered when measurement gaps configured?

0 votes
397 views

for an active UE to which DL and UL Data transmiting/receiving, if measurement gap subframes hit then where UL/DL data should be buffered and how it should maintain?

posted May 3, 2016 by Suchakravarthi Sripathi

Share this question
Facebook Share Button Twitter Share Button LinkedIn Share Button

1 Answer

+1 vote

I didn't observed the behavior of data buffering during the period of measurement gap. But logically it should be at RLC layer during this period since MAC layer already knows data is not going to be scheduled on particular sub frames.

answer May 4, 2016 by Vimal Kumar Mishra
Similar Questions
+1 vote
In TAU procedure, how the UL/DL data transfer from different TAI?

In LTE handover procedure, after UE handover to the target cell, if new TAI is not in the TAI list, the TAU will be triggered.

In HO procedure, UL/DL data has been handover to the target cell.

But before TAU, the UE doesn't register to the new MME, in the new cell, how the the DL/UL data transfer between UE and network(S-GW / P-GW) before TAU and after HO.

Also, as we know, if the TAU fails, the DL/UL data transfer will be interrupted, which network element will release the DL/UL throughput?

+3 votes
What are different Scenarios Forced Ack should be send in case of Measurement Gaps are enabled?

Please Explain all possible Scenarios and provide some good references to implement Measurement Gaps Scheduling in MAC Level...!

+1 vote
To Measurement gaps implementation(TDD) in MAC layer, please provide some references?

for efficient utilisation of resources to schedule i need some clear references about measurement gaps implementation in MAC layer wise. please provide references including specification versions.

...