top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

How to Broadcast paging and SI's when ENodeB receives ETWS Indication.

+3 votes
722 views

If once ENodeB recevies ETWS indication form MME, ENodeB should broadcast the paging message to all UE.

Inorder to send paging message with DL indication ENodeB will have UE_ID to calculate PO & PF to broadcast Paging message.

What will UE_ID in case of ETWS indication? How to calculate PO or is their any specific PO's which is their to broadcast?

posted Jul 5, 2016 by Manohar Venkat.ch

Share this question
Facebook Share Button Twitter Share Button LinkedIn Share Button

2 Answers

+2 votes

Paging message is not always specific to UE but it may be relevant for all the UEs present in a cell.
As per RRC paging message definition, it contains ETWS indication flag when it is intended for all the UEs present in cell.
Each UE wakes up after its DRX cycle gets over and read the paging message from the paging channel, if paging message contains system information modification or etws flag, UE starts reading SIBs based on the received information.

answer Jul 5, 2016 by Harshita
0 votes

Hi manohar,

For ETWS paging there is no need for ue_id because ENB is not transferring to particular UE, instead ENB will send paging in all valid paging occasion for the corresponding cell, so that all UE will receive the same in their corresponding SF. If ETWS flag is set in paging means UE will automatically acquire the SIB for further proceeding.

say E.g SF 5,9 is set as paging occasion for UE 1,2: ENB configured paging occasion is 0,4,5,9. So NEB has to transfer paging in all of these SF (0,4,5,9) so all UE will receive paging.

answer Jul 5, 2016 by Jaganathan
Hi ,
In which radio frame we have to send?
how much we have to keep on broadcasting?
As per my knowledge that is implementation specific, we can send mainly on default paging cycle because all UE will receive at-least once in default paging cycle, remaining we have to keep sending in all paging occasion until our implementation specific count exceeds. UE paging occasion will be minimum of default paging cycle or ue specific paging cycle, so if we cover default paging cycle then all UE will receive paging between those RF.

Implementation is based on probability of reception.
Similar Questions
+4 votes

When we will construct a RRC paging message with multiple paging records?
In which scenario I need to construct a RRC paging message message with multiple paging records.Suppose we have 10 UEs in idle mode and DL data notification is comming for 5 UEs at the same time,then how mme will send S1AP paging message(i.e one by one for each UE or all the message at once).If ENB is receiving all the four S1AP paging message then how RRC has to process the S1AP paging messages and how it should construct the RRC paging message (i.e whether it should send one paging record for one pcch message or it should send multiple records in one PCCH message?if multiple records then how to send the UE_ids to MAC and RLC?).

+2 votes

There are several cases when an eNodeB is configured with different values than its neighbor. Default paging cycle may be one of those parameters. I want to know, in which different scenarios each value of the default paging cycle is used ?

...