How you can enable Bulk Load Mode in TI cognos tm1?

+1 vote

668 views

posted Aug 24, 2016 by Mahie Shah

Share this question

Your comment on this post:

Email me at this address if a comment is added after mine:Email me if a comment is added after mine

Privacy: Your email address will only be used for sending these notifications.

Anti-spam verification:

To avoid this verification in future, please log in or register.

0 votes

1.In Prolog or Epilog section of TI, Bulk Load mode can be enabled.
2.It always recommended that Bulk Load Mode should be enabled in Prolog section.

answer Aug 24, 2016 by Sathish

Email me at this address if a comment is added after mine:Email me if a comment is added after mine

Privacy: Your email address will only be used for sending these notifications.

Anti-spam verification:

To avoid this verification in future, please log in or register.

Email me at this address if my answer is selected or commented on:Email me if my answer is selected or commented on

Privacy: Your email address will only be used for sending these notifications.

Anti-spam verification:

To avoid this verification in future, please log in or register.