top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

What is the difference or need of having different flavors of GTP (V2- CONTROL and V1- USER) in LTE network?

+1 vote
491 views
What is the difference or need of having different flavors of GTP (V2- CONTROL and V1- USER) in LTE network?
posted Jan 12, 2017 by anonymous

Share this question
Facebook Share Button Twitter Share Button LinkedIn Share Button

1 Answer

0 votes

GPRS Tunneling protocol has multiple variants such as GTPv1-C, GTPv1-U, GTPv2-C. If you look into GTPv1-C and GTPv2-C header then you can easily make out the difference and why GTPv2-C is being used for LTE signalling among MME, SGW and PGW . One major difference what I found GTPv2-C can piggyback multiple messages but GTPv1-C does not have support of piggybacking. However there was no requirement on change of GTPv1-U so it is being used in LTE as it is.

References
Spec 29.060
Spec 29.281
Spec 29.274
https://en.wikipedia.org/wiki/GPRS_Tunnelling_Protocol

answer Jan 13, 2017 by Harshita
Similar Questions
+3 votes
5G: Is 5G network going to use GTP based user plane between NG-RAN and UPF or something else ?

LTE network uses GTP-U based interface between eNodeB and SGW to transport user data, Is 5G network going to similar GTP based user plane between NG-RAN and UPF ?

0 votes
LTE: What is the advantage of using kernel level gtp encapsulation and de-capsulation for user plane at SGW and PGW ?

Implementation of user plane processing at the user space of node is time consuming and cpu intensive. Is there any library/solution available through which GTP encapsulation/de-capsulation can be done at kernel level to reduce delay ?

+1 vote
LTE: What does mean by fully qualified tunnel id (FTEID) in GTP control messages ?

I have seen GTP control messages and found that F-TEID consists of an IP address and 32 bit long Tunnel Id. For example: Create Session Response message contains control plane F-TEID and user plane F-TEIDs. I have a question here, why not only TEIDs are included in Create Session Response message when IP address would be common ? or Does it mean control and user plane both F-TEIDs may have different IP address ?

...