top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

What is Report on Leave IE in Event A3 Measurement config?

+1 vote
1,213 views
What is Report on Leave IE in Event A3 Measurement config?
posted Mar 15, 2019 by Gnanendra Reddy

Looking for an answer?  Promote on:
Facebook Share Button Twitter Share Button LinkedIn Share Button

Similar Questions
+4 votes
What is the difference between A3 and A6 Event in measurement report config ?

A3 :- Neighbour becomes offset better than PCell
A6 :- Neighbour becomes offset better than SCell

Please Clarify the difference

+1 vote
Does UE reports neighbor cells in order of RSRP in measurement report of A3 event ?

Does UE reports neighbor cells in order of RSRP in measurement report of A3 event ?

+2 votes
LTE: How different threshold values are derived for different event like A1, A2, A3, A4 and A5 ?

I was going through the measurement configuration sends from eNodeB to UE in RRC Connection Reconfiguration message.
I saw that multiple events have been defined and are used. Couple of parameters are considered to detect entering and leaving condition of an event for example event A1. Now I have a question "Threshold and Hys values are same for all the cell or it may different". Does the standard define the value of all these parameters or network operator defines ? If network operator does then what are points to derive these values ?

+4 votes
Does ECGI is reported in measurement report only when ENB gives the PCI for which ECGI to be reported?

I have gone through the measurement config/ report messages.I found that in meas report UE can send PCI, RSRP, RSRQ, CGI report at a time.

Will UE will send CGI report also at the same time or UE will send only when ENB request UE for the ECGI with the Report ECGI by giving pci ?

...