top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

After sending RRC connection request message, how much time UE will wait to receive RRC connection setup or reject?

0 votes
583 views
After sending RRC connection request message, how much time UE will wait to receive RRC connection setup or reject?
posted Jun 24, 2019 by anonymous

Share this question
Facebook Share Button Twitter Share Button LinkedIn Share Button

1 Answer

0 votes

It depends on the value of timer T300

This setting determines how long the UE waits for the RRC Connection Setup after sending an RRC Connection Setup Request.

T300 can be set to one of the following values: 400, 600, 800, 1000, 1200, 1400, 1600, 1800, 2000, 3000, 4000, 6000, 8000 ms.

answer Jun 25, 2019 by Sushant Bose
Thanx
commented Jun 25, 2019 by Anchal Nigam
Similar Questions
+1 vote
After sending RRC connection request message how much time UE will wait to receive RRC connection setup or reject?

After sending RRC connection request message how much time UE will wait to receive RRC connection setup or reject message.

0 votes
Suppose we are checking log and getting RRC connection reject message but there is no wait time...

Suppose we are checking log and getting RRC connection reject message but there is no wait time in this so again UE initiates the procedure. How can UE fix the bug?

+3 votes
How mme will react when it didn't receive WRITE-REPLACE WARNING RESPONSE after sending WRITE-REPLACE WARNING REQUEST.

How mme have to react when it didn't receive WRITE-REPLACE WARNING RESPONSE from a eNB after sending WRITE-REPLACE WARNING REQUEST to it.

Because of some S1-AP failure.

1) what if eNB didn't receive the WRWRequest.

2) what if eNB received the WRWRequest and cannot send WRWResponse.

+1 vote
In which IE,does DRX parameter will be configured,Is it in RRC CONNECTION SETUP, RRC RECONFIGURATION or SIB2 message?

Is DRX will by default present in UE?or will it be assigned by eNB?
If it is assigned by eNB,then in which message does it send to UE,in RRC setup or RRC reconfiguration or SIB2 message?

...