top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

LTE HO: Is it possible after successful resource allocation at target eNodeB, source eNodeB sends HO Cancel ?

+2 votes
1,274 views

Is it possible, source eNodeB has received "handover command" message from MME and now it want to cancel handover procedure ?
What could be the possible reasons when source eNodeB want to cancel ongoing handover procedure ?

posted May 30, 2014 by Harshita

Share this question
Facebook Share Button Twitter Share Button LinkedIn Share Button

2 Answers

0 votes

In 3GPP 36.413 specification mentioned that source enodeB can send HO Cancel message while handover preparation is ongoing or even HO Command message has been received. There may be a number of reasons for HO cancel, please refer cause value IE of HO Cancel message.

answer May 30, 2014 by Vikram Singh
0 votes

One of the reason can be if UE triggers A1 event again after sending measurement for HO(A3/A4/A5 event) then eNB will send HO cancel for ongoing HO preparation.

answer Oct 13, 2014 by Veer Pal Singh Yadav
Similar Questions
0 votes
LTE: What are actions taken at source eNodeB or MME in case of partial resource allocation as part of HO procedure?

When target eNodeB is not able to allocate resource for all the bearers which comes as part of Handover Request message, it sends handover request ack with partial success since "E-RABs Failed to Setup List" is present in HOReqAck message.
What MME or source eNodeB does in that case ? Does any action taken by MME for the E-RABs which failed to setup at target eNodeB or some other actions taken ?

+1 vote
LTE: What target eNodeB does in case it receives "Path switch request failure" from MME ?

As one failure message is defined in specification for the path switch procedure then what would be the behavior of target eNodeB after getting failure response from the MME ? Action would be vendor specific or standard action has been defined for this scenario ?

+1 vote
LTE HO : Why two MME UE S1AP IDs present within the S1-AP HO Request message ?

I found two MME UE S1-AP IDs i.e. MME UE S1AP ID (Mandatory) and MME UE S1AP ID 2 (optional).
I got why mandatory one is present but what's use of optional one.

Can someone please explain it ?

+2 votes
LTE: How an source eNodeB come to know about "TAI" of target eNodeB ?

In the handover required message, there is an IE target TAI. How source eNodeB came to know TAI of target eNodeB ? Is it configurable parameter or UE report as part of handover or something else.

...