On what basis an operator chooses GTP/PMIP between SGW and PDN-GW?

501 views

When exactly a PMIP based tunnel is required to establish and What are the other use cases where PMIP tunnel can/should be established?

posted Jul 17, 2014 by anonymous

Share this question

Facebook Share Button

Twitter Share Button

LinkedIn Share Button

2 Answers

If the legacy network is WCDM operator may chose GTP tunnel if it is EVDO it may chose PMIP.

answer Jul 17, 2014 by Amiya Kumar Sahoo

In short PMIP is used when UE handedover from 3GPP network i.e. LTE to Non-3GPP network.

Some operators prefer using PMIP throughout their n/w as it facilitates connecting to non-3gpp accesses, whereas some operators want only GTP as their n/w is evolved from UMTS and they dont want too much hassles in managing different transport protocols. As a result of which, a user roaming between these two will not be supported home-routed traffic, he will only be local-breakout'ed. Therefore to support both home-routed and local breakout, S/PGWs have dual stacks.

Credit: http://tech.queryhome.com/7643/pmip-or-gtp-protocol

answer Jul 18, 2014 by Salil Agrawal

Similar Questions

0 votes

PMIP or GTP protocol

S5/S8 interface, what are the factors what decide whether PMIP or GTP protocol should be used and why ?

+2 votes

Does core network need to implement GTP-based or PMIP S5/S8 interface if it is combined S-GW/P-GW?

Hi all

Because combined S-GW/P-GW is one node, so do we still need to implement the connection between them?
Is it necessary for core network to implement GTP-based or PMIP based S5/S8 interface if it is combined S-GW/P-GW?

Is there any 3GPP spec mention about combined S-GW/P-GW? what is the cons and reasons to do this?

thanks

+4 votes

LTE: What is the significance of S5 interface between L-GW and SGW ?

I have one doubt over S5 interface. Interface between SGW and PGW in lte core known as S5 interface. Now I found again S5 interface between L-GW( which is co-located with HeNB ) and SGW of core network. Can someone please explain why this interface is required ?

+2 votes

On which basis MME selects the S-GW?

When UE sends an attach request then on which bases MME selects S-GW for that UE?
does this information is passing from HSS with the subscriber profile information?

+1 vote

PDN GW address provided by the HSS in S6a-IDR

PDN connection is already established to a PDN-GW (PDN GW address was resolved by DNS resolution)
The HSS sends to the serving MME, S6a-IDR (Insert Subscriber Data) where the PGW-address (MIP6-Agent-info AVP) set to another IP-address is specified in the APN configuration.
Should the MME immediately tear down the existing PDN connection and re-establish a new connection with the PDN-GW present in the IDR message?

...