top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

LTE: what is CRE ? how to avoid it.

+2 votes
785 views

I am doing intra frequency (both cells operating on same center frequency ) handover ,but while doing handover between these two cells UE trigger CRE so RLF is happining. Please can any one suggest why and how to overcome this CRE.

posted Aug 22, 2014 by Bheemappa G

Looking for an answer?  Promote on:
Facebook Share Button Twitter Share Button LinkedIn Share Button
CRE means Cell Range expansion mainly used with the picocell i.e. expansion of the pico-cell but I believe the concept should be applicable to the macro cell also. Which only answers first part...

How to avoid the CRE is know known to me????
commented Aug 22, 2014 by Tapesh Kulkarni
Thanks for your reply.
  Let me explore more , from ue log i am getting sequences of following meassges at RRC:
        1) Received CRE trigger with cause xxxxx some number.
        2) Received phy_RL_failure .
I am not getting the relation between RLF and CRE. please can any one suggest me if have .
commented Aug 22, 2014 by Bheemappa G

Similar Questions
+2 votes
LTE: How source eNodeB get to know when it has to trigger handover required message towards MME ?

I have basic handover related query. How source eNodeB get to know when it has to trigger handover required message ? I mean to ask, how a source eNodeB come to know the threshold values of RSRP or RSRQ or both (related to target eNodeB) , required to do a successful handover towards eNodeB ? Is it due to network planning ?

+2 votes
LTE : how to configure DRX to get ECGI report ?

I have two cells having same operating frequency with different PCI's. After applying measurement config I got neighbor cell measurement report and then I am triggering for ECGI request but I am not getting ECGI report.

So I am guessing there is problem in configuration of DRX which is used to give proper idle period to UE.

Please help if any one have experience on this.

+2 votes
LTE: How different threshold values are derived for different event like A1, A2, A3, A4 and A5 ?

I was going through the measurement configuration sends from eNodeB to UE in RRC Connection Reconfiguration message.
I saw that multiple events have been defined and are used. Couple of parameters are considered to detect entering and leaving condition of an event for example event A1. Now I have a question "Threshold and Hys values are same for all the cell or it may different". Does the standard define the value of all these parameters or network operator defines ? If network operator does then what are points to derive these values ?

+1 vote
LTE: Why frequency offset is not considered for leaving and entering condition of event A6 ?

Unlike for A3 and A5 events, for A6 event frequency offset is not considered while evaluating entering and leaving condition. Can anyone please explain this particular case ?

+2 votes
How Drx configuration is usefull for UE to perform ECGI measurement ?

According to 3Gpp spec 36.331 for EUTRA , in RRC measurement configuration if purpose set to REPORTCGI, then T321 timer will be set to 1 sec.

If this is the case then where UE will use this Drx configuration? Please can any one explain me this...

...