Its all part of mobility robustness optimization.This procedure actually trigger by UE during/after Mobility.
There are 3 cases of MRO
1 > Too-Late handover
2 > Too-Early Handover
3> Wrong-Cell Handover
Each of the above failure scenario can be detected after an RRC Connection Reestablishment.UE will include a flag within RRC Connection Re-establishment Complete message to indicate that radio link failure information is available for reporting.
After detecting this flag, the eNode B can request the UE to report the radio link failure information using a UE Information Request
message. The UE provides its report using a UE Information Response message.
If RRC connection re-establishment has been completed at a cell which does not belong to the source eNode B then the eNode B
which has received the radio link failure information can signal the information to the source eNode B. This is done using the X2-AP:
Radio Link Failure Indication message.
The content of the X2-AP: Radio Link Failure Indication message is
Failure Cell PCI
ECGI
C-RNTI
Short MAC-I
RLF-Container
