top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

What MME does when it receives "S1-setup request" from eNodeB with an unknown TAC ?

+2 votes
3,618 views

I have a use case in which
ENodeB sends "S1-Setup Request" message to MME. TAC within the request is unknown for MME but at least one PLMN from the list of broadcasted PLMN is known by MME. How MME shall react ?

posted May 20, 2015 by Vimal Kumar Mishra

Share this question
Facebook Share Button Twitter Share Button LinkedIn Share Button

1 Answer

0 votes

As per the 3GPP specs 36.413, S1 setup request message is as below.

enter image description here

As per this message, LIST of plmn AND TAC are in Supported TAs IE. So if any of TAC/PLMN is unknow to MME then MME will send the S1 setup failure to eNodeB with cause "Unknown PLMN". The failure cause will be same for both if TAC is unknown or PLMN is unknow because in the s1 setup request message rejection is on the basis of Supported TAs(Criticality - Global).

answer May 20, 2015 by Veer Pal Singh Yadav
Which MME you have used to test s1-setup failure ?
commented May 20, 2015 by Vimal Kumar Mishra
What behaviour are you getting in this scenario?
commented May 20, 2015 by Veer Pal Singh Yadav
Similar Questions
+1 vote
LTE: What target eNodeB does in case it receives "Path switch request failure" from MME ?

As one failure message is defined in specification for the path switch procedure then what would be the behavior of target eNodeB after getting failure response from the MME ? Action would be vendor specific or standard action has been defined for this scenario ?

+2 votes
What's the behavior of eNodeB when MME is not responding to S1 setup request message?

What is the eNB behavior in-case MME is not responding to S1 setup request message (ie. MME is not sending S1 setup failure or success).

+1 vote
LTE: Which cause MME sends in s1-setup failure when TAI received in S1-setup request not found at MME ?

Generally MME serves a group of tracking areas and belongs to at least one PLMN.
Lets assume, MME receives S1-setup request from eNodeB with the list of supported TAs.
Now, there are three possibilities as captured below.
1. All supported TAIs match at MME
2. Not even a single TAI match at MME
3. Few TAIs match at MME

I want to know, what MME will do for case 2 and case 3 ? How it will respond to eNodeB ?
If MME responds with S1-setup failure then what would be the cause value ? I did not find any reference in 36.413 for these scenarios.

+3 votes
What MME shall perform when receiving S1 path switch request (changing tac and lac for the UE) after a NAS tau request?

What MME shall perform when receiving S1 path switch request (changing tac and lac for the UE) after a NAS tau request. Shall MME respond to UE with TAU reject (which cause code ) or not ?

...