How can we predict the data rate from the subscriber side ?

405 views

As for uplink resources we know we need to know before that how much data UE has to send and how much is in buffer. That is ok but how can we predict the data rate for that data?

posted Jun 9, 2014 by Ankur Athari

Share this question

Facebook Share Button

Twitter Share Button

LinkedIn Share Button

1 Answer

Scheduling Request message comes from UE at eNodeB and ask for radio resource in the granularity of 1ms. Whereas in lte QoS is based on Mbps (megabits per second).
As per my knowledge it is game of TFT DL as well as UL. Downlink TFT takes care of DL bit rate and UL TFT as UE takes care of uplink bit rate.

Please correct me if I am wrong.

answer Jun 9, 2014 by Harshita

Similar Questions

+2 votes

How to calculate the data rate in UE and eNodeB?

Assume we have UE and eNodeB stacks are there and through smartbits we are pumping both UL&DL data.
How to calculate the data rate in UE and eNodeB?

0 votes

And how these values are used at UE ?

What is the range of RSRP, RSRQ, RSSI and SINR value to get good data rate and how it is related to eNodeB transmition power ? And how these values are used at UE ?

+4 votes

Why India usage 2400 MHz for LTE does it has some relation with data rate?

In India we follow 2400 MHz for LTE frequency where other countries have LTE on 600-800 MHz? Does it lead to higher data rate?

+1 vote

Why the minimal MCS chosen by the eNodeB for the user?

As far as I know eNodeB calculates the number of Physical Resource Blocks allocated to each UE, based on the specific metric, then takes the minimal modulation and coding scheme to deduce the transport block size that must be allocated to each user, Why this minimal MCS ? Isn't it too sub-optimal?

+2 votes

UL Grant in case of Carrier Aggregation supported eNodeb

In case of Rel 10 supported(Carrier Aggregation) eNodeb, how does the enodeb decide as to through PDCCH of which cell UL Grant is sent ?

...