top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

SGW behaviour after a Downlink data notification failure?

+4 votes
1,155 views

When UE is idle and there is DL traffic, the SGW sends Downlink data notification to the MME.

The MME page the Mobile, if this paging fails for any reason (in my case the UE lost the radio) the MME sends downlink data notification failure to the SGW,

What happens if after some time there is more traffic downlink to the EU. Should the SGW send a new downlink data notification to the MME? How long does it wait before sending?

posted Jan 26, 2015 by anonymous

Looking for an answer?  Promote on:
Facebook Share Button Twitter Share Button LinkedIn Share Button
I believe you mean UE not EU :)

Service request should not be triggered immediately after the downlink data notification failure otherwise it will result in unnecessary flooding. However I don't know the re-commanded value of the timer after which it can be triggered again. Check if 29.274 is saying something about the timer.
I didn't find anything in the 3gpp that's why I'm asking here :)

Similar Questions
+2 votes

I know SGW sends "DDN" to MME when it receives down link data for an IDLE UE. MME already knows ARP and other information of a bearer then why SGW includes ARP in DDN for a bearer.

0 votes

I went through the call flow diagram that is shown in 23.401 specification and tried to understand data flow (down link and up link both) through indirect data tunnels. I was bit confused that's why post my query here.

+1 vote

While doing s1-based handover, indirect data forwarding tunnel procedure may be initiated. What are all position causes to get failure response from SGW ?

...