top button
Flag Notify
    Connect to us
      Site Registration

Site Registration

When these diameter errors are triggered Error_User_Unknown(5001) and Unknown_Session_ID (5002)?

+1 vote
392 views

According to the specs 5001 and 5002 occurs when IMSI and session ID are not found in the database, in what circumstances IMSI and session ID could not be found or recognized by the database?

posted Jan 22, 2016 by anonymous

Share this question
Facebook Share Button Twitter Share Button LinkedIn Share Button

1 Answer

0 votes

There can be many scenarios when this can happen -
IMSI has deregistered or move to some other HSS or you receive the message because of error in the peer node.
Session terminated and you receive the message thereafter.

answer Feb 5, 2016 by Salil Agrawal
Similar Questions
0 votes
Diameter: Getting a good amount of "DIAMETER_INVALID_AVP_VALUE" errors in our network?

we are getting a good amount of "DIAMETER_INVALID_AVP_VALUE" errors in our network, can anyone please share what will be the possible causes of the same.

+1 vote
When to set Error 'E' bit in Diameter message?

Hi,

I want to know in which scenario or which diameter messages can set the Error bit ('E') bit in request/response messages.
Also, How 'E' bit is set with Transient failures, Permanent failures and Protocol Errors.

Thanks in advance.

0 votes
Diameter : What could be the case when Diameter relay node need to be deployed in the network ?

I know the basic differences between following Diameter nodes
- Diameter Relay Agent
- Diameter Proxy Agent
- Diameter Redirect Agent

But actually I am looking for the use cases where these above nodes are deployed to strengthen my knowledge.
Thanks in advance.

+5 votes
DIAMETER: When this error code (DIAMETER_UNABLE_TO_COMPLY 5012) will prompt up?

I think any developer or tester can help me for this.

DIAMETER_UNABLE_TO_COMPLY 5012
This error is returned when a request is rejected for unspecified reasons. For sayings an unspecified reasons is very easy but as a tester if i want to verify this error code. How can i make it possible. How can i create this scenario?

For developer also it is difficult. Mostly all the scenario has been covered by RFC's. So for development as well as for testers this could be a challenge to generate/ test this error code. Can anybody share some words on this ?

...